Fluorescence Immunoassay Analyzer, a quantitative instrument that tests quantitative itesms

1. Introduction:
The Test Device and instrument are for in vitro diagnostic use only.

This instrument is suitable for laboratories with professional testing ability in medical institutions, such as central laboratory, door/emergency laboratory, clinical department and physical examination center. It is equipped with a built-in Test Device Holder. The Test Device Holder will appear through the opening on the front surface of the instrument.

The Power ON/OFF Switch, located on the left of the instrument, which powers the Immunofluorescence Analyzer.The instrument has a built-in printer.This instrument is compact, portable, and easy to operate for fluorescence detection to quantify concentration of various kind of analytes in human blood or urine or feces.This instructions for use introduce the performance and related information of the product and contains graphical procedures for your convenience. 

2 Test Principle
Immunofluorescence Analyzer uses an LED as the Excitation Light Source. The emitted light from the fluorescence microspheres is collected and converted into an electrical signal. The signals are closely related to the amount of fluoresceing dye molecules present on the spot under examination.

After a sample is applied to the Test Device, the Test Device is inserted into Immunofluorescence Analyzer and the concentration of the analyte is calculated by a pre-programmed calibration process. Immunofluorescence Analyzer can only accept Test Devices that are designed specifically for use with this instrument.


3.Basic Specification
Excitation light source： LED
Excitation spectrum： Central wavelength λ0=365nm
Absorption spectrum： Central wavelength λ1=610nm

Interface： Serial port、USB、Ethernet network
Built-in Printer： Thermal printer
Size： 280X 280 X 170 mm ±5mm
Weight： 2Kg ±100g
Repeatability： CV≤15%
Stability： CV≤15%

4.Operating Environment: Indoor use
Ambient temperature: 5℃~40℃
Relative humidity: 10%-80%（non-condensing）
Atmospheric pressure: 860hPa~1060hPa
Altitude: Up to 2000m
Pollution degree： 2
Voltage: 100-240VAC±10%
Power frequency: 50/60Hz
Input power: 60VA